1. Gentle ankle movement
10–20 repetitions, 1–3 times daily.
- Action.
- Sit with the foot supported. Slowly move the ankle up and down through an easy range.
- Technique.
- Do not force a stretch. Follow any boot, fracture or repair restrictions.
Back Pain Doctor
Back Pain Doctor · Dr Joshua Hatch · backpaindoctor.com.au
Syndesmosis Injury (High Ankle Sprain)
Progressive rehabilitation and graded return to activity
Before you start
Use this programme for an assessed condition when exercise is appropriate. An acute fracture, tendon rupture, unstable injury or recent operation may need different restrictions. Any specific protection or surgical instructions take priority.
A high ankle sprain affects the ligaments between the shin bones. Stability determines whether rehabilitation or surgical treatment is appropriate.
Begin this programme only once the injury is confirmed stable and loading is allowed.
Mild familiar discomfort up to about 3 out of 10 may be acceptable if steady and movement stays controlled. Sharp or increasing pain is a reason to stop. Pain, swelling and function should return to baseline by the next morning. This is a practical guide, not a proven safety threshold.
Follow boot and weight-bearing restrictions. Avoid forced ankle rotation or dorsiflexion. Delay impact until the treating team permits it.
When symptoms increase
Reduce the provoking movement, repetitions or resistance by about one third to one half. Keep other comfortable activity where appropriate. Do not add harder exercise until the response is stable. A sudden major change needs assessment.
Begin with one set if needed. Practise gentle movement daily if it helps; perform strengthening on 2–3 non-consecutive days each week. Rest 30–60 seconds between easy sets. You do not need to force the full dose on the first day.
10–20 repetitions, 1–3 times daily.
2 sets of 12–15.
2–3 sets of 12–15.
Ready for Phase 2
Ordinary walking is comfortable without a limp and the early exercises do not increase symptoms the next morning.
Follow boot and weight-bearing restrictions. Avoid forced ankle rotation or dorsiflexion. Delay impact until the treating team permits it.
Use 2–3 non-consecutive strength days each week and rest 60–120 seconds between sets. Begin with a resistance that leaves a few controlled repetitions in reserve. Add repetitions first, then a small amount of resistance.
2 sets of 10–15.
2–3 sets of 8–15 each side.
3 holds of 20–30 seconds each side.
Ready to add Phase 3
Build towards 20 controlled heel raises and 30 minutes of level walking, as appropriate to the diagnosis. Do not force a painful or structurally restricted foot.
Begin this programme only once the injury is confirmed stable and loading is allowed. When the top repetition range is easy on several sessions, increase resistance slightly and return to the lower end. Keep the range and movement quality consistent. Avoid increasing weight, repetitions and frequency together.
Continue strength work on 2–3 days weekly. Add one new demand at a time. If impact is part of the programme, allow 48–72 hours between demanding impact sessions initially and reduce the strength volume on those days.
2–3 sets of 6–10 each leg.
Begin with 2 sets of 10; build to 2 sets of 20.
Begin with 2 sets of 5; build towards 15–20 in one set.
Ready to increase real activity
For running or jumping, first tolerate single leg balance, repeated calf raises and low hops with good control and no next-day flare. Do not hop until medically permitted for the injury.
Build strength and hopping before running, cutting and sport after stability and performance review. The final stage should reflect the real task: carrying, lifting, stairs, walking, running or sport. You can finish rehabilitation for daily life without needing to complete running or jumping drills that your activity does not require.
Build strength and hopping before running, cutting and sport after stability and performance review.
| Stage | What to build |
|---|---|
| Everyday function | Use comfortable movement and daily tasks in manageable blocks. Establish a stable next-day response. |
| More demanding activity | Increase duration before adding substantial load, speed, hills or more complex positions. |
| Specific work or sport | Practise the actual task at reduced intensity and duration, then progress it on separate occasions. |
| Full participation | Complete the required activity repeatedly with control and confidence, without a significant next-day flare. Injury-specific clearance may still be needed. |
Use 2–3 non-consecutive strength days, with comfortable mobility or easy activity between them. Start a new activity at less than your usual duration or intensity. Keep harder sessions apart and leave more recovery time when symptoms are still increased. For tendon loading, the condition-specific frequency on the exercise pages takes priority.
After the stated walking, strength and impact checks are met and running is permitted, try 30 seconds of easy jogging followed by 90 seconds of walking, repeated 6–8 times on flat ground. Repeat on 2–3 separate occasions before extending the jogging interval. Leave 48–72 hours between sessions initially. Reduce or stop impact if symptoms increase; shin or bone-related pain should remain pain-free.
Seek prompt assessment for inability to bear weight, a hot red swollen joint, progressive weakness or numbness, a focal bony pain or major new swelling. Sudden calf swelling, chest pain or breathlessness needs urgent assessment. Book reassessment if progress has stalled for 4–6 weeks, function is deteriorating or the same progression repeatedly causes a flare. Do not wait for that interval when a warning symptom is present.
The programme follows current rehabilitation principles. Exercise selection, sets and progression checks are practical starting prescriptions rather than a trial-validated complete protocol.
Dr Joshua Hatch | The Back Pain Doctor. Handout prepared 1 Nov 2026.