Back Pain Doctor · Dr Joshua Hatch · backpaindoctor.com.au

Shin Splints

Progressive rehabilitation and graded return to activity

Before you start

Use this programme for an assessed condition when exercise is appropriate. An acute fracture, tendon rupture, unstable injury or recent operation may need different restrictions. Any specific protection or surgical instructions take priority.

Understanding the condition

Shin splints cause exercise-related pain along the inner tibial border. Symptoms should be assessed to exclude a bone stress injury where the pattern is concerning.

Your main rehabilitation goals

Temporarily remove painful impact and rebuild calf and leg capacity.

  1. Phase 1 Comfortable movement and early loading
  2. Phase 2 Strength and controlled resistance
  3. Phase 3 Functional capacity and return to activity

Pain and recovery guidance

Keep the affected area pain-free during exercise and impact. Stop at pain rather than trying to warm through it. Do not progress if pain returns later that day or the next morning.

Condition specific precautions

Keep shin exercises pain-free. A small focal bony tender spot, night pain or pain with walking needs review; do not keep running through it.

When symptoms increase

Reduce the provoking movement, repetitions or resistance by about one third to one half. Keep other comfortable activity where appropriate. Do not add harder exercise until the response is stable. A sudden major change needs assessment.

Phase 1 Comfortable movement and early loading

Starting point
Exercise is permitted
Main focus
Comfort and control
Progression
Function and recovery. Criteria before calendar

Begin with one set if needed. Practise gentle movement daily if it helps; perform strengthening on 2–3 non-consecutive days each week. Rest 30–60 seconds between easy sets. You do not need to force the full dose on the first day.

Seated heel raise: illustration of the exercise

1. Seated heel raise

2–3 sets of 12–15.

Action.
Sit with feet flat and knees bent. Raise the heels while keeping the balls of the feet on the floor, then lower slowly.
Technique.
Take about 2 seconds each way. Begin without added resistance.
Gentle ankle movement: illustration of the exercise

2. Gentle ankle movement

10–20 repetitions, 1–3 times daily.

Action.
Sit with the foot supported. Slowly move the ankle up and down through an easy range.
Technique.
Do not force a stretch. Follow any boot, fracture or repair restrictions.
Supported single leg balance: illustration of the exercise

3. Supported single leg balance

3 holds of 20–30 seconds each side.

Action.
Stand beside a sturdy chair. Lift one foot and balance on the other leg, then change sides.
Technique.
Use fingertip support. Keep the pelvis level and stance knee relaxed.

Ready for Phase 2

Ordinary walking is comfortable without a limp and the early exercises do not increase symptoms the next morning.

Applying this to your condition

Keep shin exercises pain-free. A small focal bony tender spot, night pain or pain with walking needs review; do not keep running through it.

Phase 2 Strength and controlled resistance

Starting point
Phase 1 is tolerated
Main focus
Progressive strength
Progression
Function and recovery. Criteria before calendar

Use 2–3 non-consecutive strength days each week and rest 60–120 seconds between sets. Begin with a resistance that leaves a few controlled repetitions in reserve. Add repetitions first, then a small amount of resistance.

Supported double leg heel raise: illustration of the exercise

4. Supported double leg heel raise

2–3 sets of 10–15.

Action.
Hold a chair lightly. Raise the heels, then lower slowly to the floor.
Technique.
Keep the knees straight but relaxed. Keep pressure through the ball of each foot.
Loaded seated heel raise: illustration of the exercise

5. Loaded seated heel raise

3 sets of 8–15 each leg.

Action.
Sit with one foot flat, knee bent. Secure a cushioned weight on the lower thigh above the knee. Lift and lower the heel.
Technique.
Hold the weight securely. Start light and increase only after several well-tolerated sessions.
Supported single leg heel raise: illustration of the exercise

6. Supported single leg heel raise

2–3 sets of 8–15 each side.

Action.
Stand on one leg with fingertip support. Lift the heel and lower slowly to the floor.
Technique.
Use two feet to rise and one to lower if needed. Maintain heel height and control.

Ready to add Phase 3

Build towards 20 controlled heel raises and 30 minutes of level walking, as appropriate to the diagnosis. Do not force a painful or structurally restricted foot.

Applying this to your condition

Temporarily remove painful impact and rebuild calf and leg capacity. When the top repetition range is easy on several sessions, increase resistance slightly and return to the lower end. Keep the range and movement quality consistent. Avoid increasing weight, repetitions and frequency together.

Phase 3 Functional capacity and return to activity

Starting point
Phase 2 is tolerated
Main focus
Task specific capacity
Progression
Function and recovery. Criteria before calendar

Continue strength work on 2–3 days weekly. Add one new demand at a time. If impact is part of the programme, allow 48–72 hours between demanding impact sessions initially and reduce the strength volume on those days.

Low step up: illustration of the exercise

7. Low step up

2–3 sets of 8–12 each leg.

Action.
Step onto a stable 10–15 cm step. Push through the leading leg to stand tall, then step down slowly.
Technique.
Use a rail for balance. Keep the knee over the middle toes.
Small double leg hops: illustration of the exercise

8. Small double leg hops

Begin with 2 sets of 10; build to 2 sets of 20.

Action.
Make small hops on both feet, only a few centimetres high. Land softly in the same place.
Technique.
Use only after the stated impact criteria are met. Stop at increasing pain or loss of control.
Small single leg hops: illustration of the exercise

9. Small single leg hops

Begin with 2 sets of 5; build towards 15–20 in one set.

Action.
After double leg hops are comfortable, make small hops in place on one leg, then the other.
Technique.
Keep the hops low. Stop for pain, limping or unstable landings.

Ready to increase real activity

For running or jumping, first tolerate single leg balance, repeated calf raises and low hops with good control and no next-day flare. Do not hop until medically permitted for the injury.

Applying this to your condition

Achieve pain-free brisk walking, controlled single leg calf raises and low hops before a gradual walk-jog return. The final stage should reflect the real task: carrying, lifting, stairs, walking, running or sport. You can finish rehabilitation for daily life without needing to complete running or jumping drills that your activity does not require.

Return to activity and maintain progress

Achieve pain-free brisk walking, controlled single leg calf raises and low hops before a gradual walk-jog return.

Stage What to build
Everyday function Use comfortable movement and daily tasks in manageable blocks. Establish a stable next-day response.
More demanding activity Increase duration before adding substantial load, speed, hills or more complex positions.
Specific work or sport Practise the actual task at reduced intensity and duration, then progress it on separate occasions.
Full participation Complete the required activity repeatedly with control and confidence, without a significant next-day flare. Injury-specific clearance may still be needed.

A practical weekly structure

Use 2–3 non-consecutive strength days, with comfortable mobility or easy activity between them. Start a new activity at less than your usual duration or intensity. Keep harder sessions apart and leave more recovery time when symptoms are still increased. For tendon loading, the condition-specific frequency on the exercise pages takes priority.

A first return to jogging

After the stated walking, strength and impact checks are met and running is permitted, try 30 seconds of easy jogging followed by 90 seconds of walking, repeated 6–8 times on flat ground. Repeat on 2–3 separate occasions before extending the jogging interval. Leave 48–72 hours between sessions initially. Reduce or stop impact if symptoms increase; shin or bone-related pain should remain pain-free.

When to seek review

Seek prompt assessment for inability to bear weight, a hot red swollen joint, progressive weakness or numbness, a focal bony pain or major new swelling. Sudden calf swelling, chest pain or breathlessness needs urgent assessment. Book reassessment if progress has stalled for 4–6 weeks, function is deteriorating or the same progression repeatedly causes a flare. Do not wait for that interval when a warning symptom is present.

Evidence and practical limits

The programme follows current rehabilitation principles. Exercise selection, sets and progression checks are practical starting prescriptions rather than a trial-validated complete protocol.

  • Moen MH and colleagues. Treatment of medial tibial stress syndrome in athletes. 2012. doi 10.1186/1758-2555-4-12. George ERM and colleagues. Criteria and Guidelines for Returning to Running Following a Tibial Bone Stress Injury. Sports Med. 2024. doi:10.1007/s40279-024-02051-y

Dr Joshua Hatch | The Back Pain Doctor. Handout prepared 1 Nov 2026.

Ready for a clearer plan for your back or musculoskeletal pain?

Book an assessment with Dr Joshua Hatch.

Your assessment focuses on understanding the likely source of your pain and the most appropriate non-surgical options for your diagnosis, with the aim of reducing pain and improving function.

You must have your own regular GP before booking. This service works alongside your GP for focused care. Booking requirements.

Book an appointment
Book an appointment with Back Pain Doctor